Handrails and balustrades
Ends, corners, stair runs. A set angle, not “by eye”.
Services
Tube bending to size
Bends, elbows and handrails from tube — carbon steel, stainless within machine limits, from a single piece. Przełęk near Nysa.
Scope
What we bend most often
From a handrail elbow to a few identical bends — private customers and companies.
Bends and elbows
To size, up to 180°. For welding frames, stands, canopies.
Installation pipe
Black pipe in the standard diameters we have dies for.
Frames and stands
Table legs, brackets, supports. One piece or several identical angles.
Stainless
Up to Ø 25 mm. Thinner wall and larger diameter — we check ovality first.
A single piece
No series required. We will bend one length, or a short repeatable run for welding.
Bending a handrail or an elbow by hand flattens the tube and guesses the angle. Here the tube goes in a die: a set angle up to 180°, repeatable, without a torch.
This is mandrel-less bending — it suits typical installation pipe and handrails, not paper-thin wall and a tight radius. Carbon steel up to Ø 42.4 mm at 3 mm wall; stainless up to Ø 25 mm. Dies on site: 17.5 / 21.3 / 26.9 / 33.7 / 40 / 42.4 mm.
Plant in Przełęk near Nysa. Bring the tube or send diameter, wall and angle — we will say whether it fits a die.
What fits a die
Ø 42.4 mm
carbon steel, wall up to 3 mm
Ø 25 mm
stainless steel
180 °
maximum bend angle
6 dies
17.5–42.4 mm on site
Have order documentation
or a service to carry out?
Send us drawings or a short description — we will reply with a quote within 48 hours.